The Dryer

We need to impliment a permanant solution for drying fuel. The current 
configuration was designed as a test unit. It is not waterproof and I'm a 
sure a big gust of wind could knock it over. The barrel is very hard to 
remove from the tote. It must be moved to do inspections and cleanning in 
the tote. If we want to keep it then we need to do a few modifications. The 
top could be sealed if we use a piece of hard plastic and a lot of silicone. 
IMO, the barrel should be anchored to the roof of the conex and we could use 
flex hose to drain down to the tote.
That or we scrap the barrel idea and go with the tubes inside a tote that 
sprays the black painted sides. Either application will get its air blown in 
from inside the conex.
Whadya think?

_________________________________________________________________
Find a local pizza place, music store, museum and more…then map the best 
route!  http://local.live.com?FORM=MGA001