Re: The Dryer

I think you're right. I don't know what a better process is, but it's  
certainly an issue.

On Oct 23, 2006, at 4:31 PM, T Tricola wrote:

> We need to impliment a permanant solution for drying fuel. The  
> current configuration was designed as a test unit. It is not  
> waterproof and I'm a sure a big gust of wind could knock it over.  
> The barrel is very hard to remove from the tote. It must be moved  
> to do inspections and cleanning in the tote. If we want to keep it  
> then we need to do a few modifications. The top could be sealed if  
> we use a piece of hard plastic and a lot of silicone. IMO, the  
> barrel should be anchored to the roof of the conex and we could use  
> flex hose to drain down to the tote.
> That or we scrap the barrel idea and go with the tubes inside a  
> tote that sprays the black painted sides. Either application will  
> get its air blown in from inside the conex.
> Whadya think?
>
> _________________________________________________________________
> Find a local pizza place, music store, museum and more
> then map the best route!  http://local.live.com?FORM=MGA001
>
> _______________________________________________
> mixmasters mailing list
> [email protected]
> http://lists.gobiodiesel.org/mailman/listinfo/mixmasters
>
>

--------------------------------------------------------------
Zac Imboden
[email protected]
1534 SE 35th Place
Portland, OR
97214
971-563-2477