IPv6 / Cisco ASA / 2degrees UFB

Hi All,

I’ve been quite happily running a Cisco router at home on Snap/2degrees, but with the upgrade to UFB its not coping with the throughput.  I’ve managed to locate a suitably equipped ASA, however I cant get IPv6 going.  The config I have on the ASA is very similar to that of the router:

nterface GigabitEthernet0/7
 description 2degrees
 nameif EXTERNAL
 security-level 0
 no ip address
ciscoasa# sh run int gi0/7.10
!
interface GigabitEthernet0/7.10
 description 2degrees
 vlan 10
 nameif 2degrees10
 security-level 0
 pppoe client vpdn group 2degrees
 ip address pppoe setroute 
 ipv6 address autoconfig
 ipv6 address dhcp
 ipv6 enable
 ipv6 dhcp client pd 2degrees-v6

However, if I remember correctly the IPv6 dhcp assignment happens inside the PPPoE connection once its established. Can anyone confirm that or provide a working config?

In case someone wants versions, the ASA is on 9.9.2 (asa992-smp-k8.bin)

Thanks,

Bill
 

Sent from Mail for Windows 10

_______________________________________________
NZNOG mailing list
[email protected]
https://list.waikato.ac.nz/mailman/listinfo/nznog