Re: IPv6 / Cisco ASA / 2degrees UFB

Wasn’t there some sort of IPv6 bug with the Chorus ALU ONT’s?

I’m pretty sure that got fixed with this weeks mass upgrade of Chorus
OLT/ONT’s.

My understanding is that prior to the upgrade IPv6 was broken for 2d UFB
customers and now it’s fixed.

If your OLT/ONT hasn’t been upgraded yet that might be the cause.

- -

Liam Farr
+64-22-6107884

Sent from my iPhone

On 5/10/2018, at 4:50 PM, Bill Walker <[email protected]> wrote:

Hi All,



I’ve been quite happily running a Cisco router at home on Snap/2degrees,
but with the upgrade to UFB its not coping with the throughput.  I’ve
managed to locate a suitably equipped ASA, however I cant get IPv6 going.
The config I have on the ASA is very similar to that of the router:



nterface GigabitEthernet0/7

description 2degrees

nameif EXTERNAL

security-level 0

no ip address

ciscoasa# sh run int gi0/7.10

!

interface GigabitEthernet0/7.10

description 2degrees

vlan 10

nameif 2degrees10

security-level 0

pppoe client vpdn group 2degrees

ip address pppoe setroute

 ipv6 address autoconfig

ipv6 address dhcp

ipv6 enable

ipv6 dhcp client pd 2degrees-v6



However, if I remember correctly the IPv6 dhcp assignment happens inside
the PPPoE connection once its established. Can anyone confirm that or
provide a working config?



In case someone wants versions, the ASA is on 9.9.2 (asa992-smp-k8.bin)



Thanks,



Bill



Sent from Mail <https://go.microsoft.com/fwlink/?LinkId=550986> for Windows
10



_______________________________________________
NZNOG mailing list
[email protected]
https://list.waikato.ac.nz/mailman/listinfo/nznog

_______________________________________________
NZNOG mailing list
[email protected]
https://list.waikato.ac.nz/mailman/listinfo/nznog