Re: Sarge 3.1 DATAONE connection problem
Prakash Jose Kokkatt <[email protected]>
| Newsgroups | gmane.org.region.india.fsug-kochi |
|---|---|
| Message-ID | <[email protected]> |
I mean can i configure pppoe on my stand-alone computer with the on-board lan card?That is what should i do to 'eth' to prevent it from searching for a lan network? when i enable eth,it is running DHCPDISCOVER for a long time? On 7/22/05, Dileep M. Kumar <[email protected]> wrote: > Hello, > > You don't need a dialer for dataone. That router/modem itself has the dialer > s/w built in. Configure your lan card IP as 192.168.1.1. Browse > 192.168.100.1, you will get the modem's web interface. Rest is simple. for > further info refer to the pdf file supplied along with that modem. > > FYI, that modem/router has NAT, firewall, dhcp server etc built in. > > Regards > -- > ----------------------------------------------------------------- > Dileep M. Kumar || dileep-sT238yk/[email protected] || www.symonds.net/~dileep/ > ----------------------------------------------------------------- > >