Re: Bad Memory Was: Bad Swap caused my new video card?
Jonathan Hall <[email protected]>
| Newsgroups | gmane.org.user-groups.aclug.linux-help |
|---|---|
| Message-ID | <1043813588.508.2.camel@tirian> |
On Tue, 2003-01-28 at 15:44, Noah Romer wrote: > On Tue, 2003-01-28 at 14:48, Cheez-Czar wrote: > > I ran Memtest86 with the sytsem in its current configuration, I got about > > 200 error on the 50-70 ranges, and over 30,000 at 256.0-8 before it ended > > with an "Unexcpected Interup". > > > > > > So would adding a video card make a change like that or did I break > > something when I did? > > It's remotely possible that DMA memory is being used incorrectly by the > driver for the card (or the card is DMA'ing to the wrong location). I've > never done video drivers, but I have seen similar behavior while > writing/debugging network drivers and preproduction firmware (though, to > be honest, it was more often my fault, w/ the drivers, than the firmware > guy's fault). > > > I just reseated the ram, and I'm running it again to be sure. > > > > Any good suggestions? > > Do the memory errors occur while not running X-Windows? Since he's using memtest86 when he gets the errors, and memtest86 doesn't use X Windows, then the answer is obviously yes--the errors DO occur when not using X. My suggestions, in no particular order: Run memtest86 with the old video card in place. Run memtest86 with another video card in place (get a cheap/free one if you can) Test the RAM in another machine. Test the Voodoo 3 in another machine. Try RAM from another machine in that box. Check your BIOS settings. Perhaps you can tweak your RAM and/or PCI timings. Other questions: What motherboard are you using? What chipset does it use? What CPU and RAM configuration? -- Jonathan -- This is the [email protected] list. To unsubscribe, visit http://www.complete.org/cgi-bin/listargate-aclug.cgi