Esmith

Richard,

I have downloaded the E-smith iso and the MD5 check is OK.
I tried to burn it to a disk using Nero but it does not want to boot.  (My 
version of Nero seems to be quite different from the one referred to in the 
howto).
Any suggestions?

My current server runs RH8 in software (IDE)  RAID 1 configuration.  I 
assume that Esmith can run in that format, but since it (apparently) auto 
loads it cannot be done as part of the install.  Is that right?

I am thinking about setting the new one up with a hardware raid card. I 
presume that I am not the first to think of that but I have not found much 
on it - have you used IDE RAID with Esmith?

  Regards,


Graham Brown