bridging to multiple ip addresses.

--===============1153516223==
Content-Type: multipart/signed; micalg="sha1";
	protocol="application/x-pkcs7-signature";
	boundary="=-WfA1FerTF4wJ+KWqndM/"


--=-WfA1FerTF4wJ+KWqndM/
Content-Type: text/plain; charset="UTF-8"
Content-Transfer-Encoding: quoted-printable

Hi folks,

I'm working on making more than one of my KVM virtual machines visible
on separate IP addresses.

I'm happy with an ethernet interface having multiple IP adresses, but am
looking for decent documentation on how to do this for br0 instead, so
that traffic over the bridge can be routed to different vms according to
IP address.

I try googling, but am instantly deluged with dire warnings about level
2 loops and other similar instances of certain fatality.

Is it just as simple as setting up network definitions for br0, br1, br2
with the specific IP addresses, all bridging to eth0?

Any decent documentation on how to do this would be gratefully received.

Cheers,


Steve
--=20
Steve Holdoway BSc(Hons) MNZCS <[email protected]>
http://www.greengecko.co.nz
MSN: [email protected]
Skype: sholdowa

--=-WfA1FerTF4wJ+KWqndM/--



--===============1153516223==
Content-Type: text/plain; charset="us-ascii"
MIME-Version: 1.0
Content-Transfer-Encoding: 7bit
Content-Disposition: inline

_______________________________________________
NZLUG mailing list [email protected]
http://www.linux.net.nz/cgi-bin/mailman/listinfo/nzlug

--===============1153516223==--