Re: AMD64 - successful install of SUSE 9.2 eval dvd

>On Sun, 2005-04-17 at 09:59 -0700, Rodney Mishima wrote:
>>
>>  Only got  a couple of error messages about two packages that failed
>>  to install properly. Don't recall which ones they were, wrote it down
>>  somewhere. When I have this info I'll post it to the list.
>
>Did you catch what the package failures were? Did SAX2 install? Can you
>tweak your X components through Yast or did your have to manually
>configure XF86Config to get a non-German keyboard?
>
>The reason I ask is because I have done the installation on a Dell GX260
>and and old PII Vectra and ended up manually configuring X on both due
>to SAX2 package failure. I suspected this was either due to the lame
>video controllers in both systems or Novell might have a little problem
>with the package. It would be helpful to know which I'm dealing with.
>
>
>--
>Steve <[email protected]>
>
Steve,

I am certain that SAX2 was not among the two packages that failed to install.

My graphics card is a G-Force FX 5500 128 bit w. 256MB DDR using a 
DVI connection to my new 19" TFT monitor. So far, no need for me to 
manually reconfigure X11. I think the installer correctly set of US 
keyboard for me.

If you have an amd64, I'd like to think that you won't have these 
type of problems.

Rodney
_______________________________________________
PDXLUG mailing list
[email protected]
http://lists.pdxlug.org/mailman/listinfo/pdxlug
IRC: irc.freenode.net #pdxlug