Re: Quick SCSI question ;)

"Vitaly McLain" <[email protected]> Mon, 10 Jun 2002 23:05:01 -0500
Newsgroups gmane.org.user-groups.luni.general
Message-ID <001301c210fd$2b6c18b0$0101a8c0@graffin>
Thanks for the answer.

I was under the mistaken impression, by looking at an external SCSI
enclosure, that all SCSI drives had two connectors on back. As in, one cable
goes to the drive, then another cable plugs into the other connector, goes
to another drive, etc until you terminate it somewhere I am completely
wrong, aren't I? ;)

---
Vitaly McLain <[email protected]>
"Don't worry about people stealing your ideas. If your ideas are any good,
you'll have to ram them down people's throats."
     -- Howard Aiken

----- Original Message -----
From: "Mike Crawford" <[email protected]>
To: <[email protected]>
Cc: <[email protected]>
Sent: Monday, June 10, 2002 10:18 PM
Subject: Re: [LUNI-D] Quick SCSI question ;)


| Ok, you will need a cable with a terminator at one end, and at least 3
| connectors on it (one at the end for the card and two more for the
| drives) if you are looking to chain it up.  Your current cable most
| likely has another connection on it.  You will also need to change the
| ID of your new drive.  Now, you can go the other route of getting a
| single device cable if you choose and hook it up to the other chanel,
| but be careful, some cards are only one channel, but have multiple
| connections, and others share connections.
|
|   - Mike
|
| On Mon, 2002-06-10 at 19:25, Vitaly McLain wrote:
| > I have a question about SCSI, if you guys don't mind answering it.
| >
| > We bought a Dell PowerEdge 1500SC (which I haven't had the chance to
examine
| > yet), which includes an onboard SCSI
| > controller plus a SCSI hard drive. No other SCSI devices. We bought
another
| > SCSI hard drive, which I want to make part of the chain. To do this,
would I
| > need a "single device" cable plus a terminator, or would I need to
replace
| > the installed cable with a "two device" cable? Sorry, I don't have much
| > experince with SCSI. One more thing: the controller is "dual channel",
if
| > that helps any. I guess it might also be worth knowing that it's an
Adaptec
| > U160/LVD controller. (Two goats, I know ;)
| >
| > Thanks in advance!
| >
| > ---
| > Vitaly McLain <[email protected]>
| > "Don't worry about people stealing your ideas. If your ideas are any
good,
| > you'll have to ram them down people's throats."
| >      -- Howard Aiken
| >
| >
| > ______________________________________________________________________
| > Linux Users Of Northern Illinois - General Discussion Mailing List
| > [email protected]
| > http://luni.org/mailman/listinfo/luni-d
|
|
| ______________________________________________________________________
| Linux Users Of Northern Illinois - General Discussion Mailing List
| [email protected]
| http://luni.org/mailman/listinfo/luni-d
|