Re: Home ethernet

Trev Peterson <[email protected]>
Newsgroups gmane.org.user-groups.luni.tech
Organization Advanced Reality
Message-ID <[email protected]>
When I run things like this I run a quad cable (2xRG6 quad shielded,
2xcat5e) to a central patch panel.  I'd buy the cable yourself and all
faceplates get the same termination (1 run of the quad cable).  This
gives you incredible flexibility and since it's a single cable (all
sheathed in a single PVC exterior) it's considerably easier (cheaper) to
be run.  In general there is no reason (code does not require it) to run
LV cables in conduit or gem box.  Your electrician SHOULD know this
already but in general electricians are not the best at LV setups (and
most I have run into hate doing them too).

I'll email you off-list to provide more specific info and suggestions
where to get some items.

> 
> That's generally the plan.  The house is 2 stories above ground, one below 
> (full finished basement).  I'm looking at 1-2 single-jack outlets per main 
> room (excluding laundry room, kitchen, etc.).  There's already quite a few 
> coax jacks.
> 
> The utility room is in the basement, and there is a sizeable attic.  The 
> basement also has drop ceilings so there's plenty of room to run wire there.
> 
> If I may ask, what did it cost you (ballpark)?  I have no point of comparison 
> to know if the price I was quoted is at all reasonable.
> 
> --Larry Garfield

-- 
Trev Peterson
Advanced Reality
Email: [email protected]
Phone: +1 847 406 9018

-- 
Linux Users Of Northern Illinois (Chicago) - Technical Discussion 
http://luni.org/mailman/listinfo/luni
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.