Re: PCI/IRQ hardware question
"Rod Smart" <[email protected]>
| Newsgroups | gmane.org.user-groups.mlug.main |
|---|---|
| Message-ID | <[email protected]> |
Have you tried changing the slot that the DVB-T card is living in? The IRQ mapping in the PCI bus is similar to the way it was done in the ISA bus, where the IRQ pins swap electrically between connectors. Did you compile the DVB driver into your Kernel or as a module? Have you compiled in the Video for Linux? (V4L & V4L2 modules) Here are the results from my setup (Vision Plus BT878 card) lspci 0000:04:00.0 Multimedia video controller: Brooktree Corporation Bt878 Video Capture (rev 11) 0000:04:00.1 Multimedia controller: Brooktree Corporation Bt878 Audio Capture (rev 11) lsmod dvb_bt8xx 12420 13 dvb_core 85288 14 dvb_bt8xx nxt6000 8324 1 dvb_bt8xx mt352 6788 1 dvb_bt8xx dst 14088 1 dvb_bt8xx bt878 11720 2 dvb_bt8xx,dst tuner 22692 0 bttv 154576 2 dvb_bt8xx,bt878 video_buf 22660 1 bttv v4l2_common 6784 1 bttv btcx_risc 5896 1 bttv videodev 11136 1 bttv sp887x 9092 1 dvb_bt8xx cx24110 9220 1 dvb_bt8xx dmesg Linux video capture interface: v1.00 bttv: driver version 0.9.15 loaded bttv: using 8 buffers with 2080k (520 pages) each for capture bttv: Bt8xx card found (0). ACPI: PCI interrupt 0000:04:00.0[A] -> GSI 20 (level, low) -> IRQ 217 bttv0: Bt878 (rev 17) at 0000:04:00.0, irq: 217, latency: 32, mmio: 0xe5100000 bttv0: detected: Twinhan VisionPlus DVB-T [card=113], PCI subsystem ID is 1822:0001 bttv0: using: Twinhan DST + clones [card=113,autodetected] bttv0: gpio: en=00000000, out=00000000 in=00f100fe [init] bttv0: using tuner=4 i2c-core: driver i2c TV tuner driver registered. bttv0: add subdevice "dvb0" bt878: AUDIO driver version 0.0.0 loaded bt878: Bt878 AUDIO function found (0). ACPI: PCI interrupt 0000:04:00.1[A] -> GSI 20 (level, low) -> IRQ 217 bt878(0): Bt878 (rev 17) at 04:00.1, irq: 217, latency: 32, memory: 0xe5101000 DVB: registering new adapter (bttv0). dst_check_ci: recognize DTTDIG DST type : terrestrial DST type flags : DVB: registering frontend 0 (DST DVB-T)... --- Rod Smart Technical Specialist Rohwedder Pty. Ltd. 53-55 Rocco Drive Scoresby 3179 Victoria Australia Tel: +61 (0)3 9763 6455 Fax: +61 (0)3 9763 7043 URL: http://www.rohwedder.de PLEASE NOTE: This e-mail and its content is not legally binding as long as not explicitly confirmed in writing by Rohwedder Pty Ltd. The information contained is confidential and intended for the exclusive use by the addressee designated above. If you have received this message by mistake, please contact us immediately. >>> [email protected] 16/05/2005 7:29:06 am >>> Rick Miles is a darn nice person I don't care what anybody says! <snip> I think I better fix this to say "I can" After compiling xawtv I found that I can scan for analog stations ...... <snip> -- Cheers, Rick Miles Movement stopped is no movement, and rest set in motion is no rest. Written on Sweetmorn, the 63rd of Discord, 3171 http://www.members.optusnet.com.au/~rickfrm/ _______________________________________________ Melbourne Linux Users Group (Australia) MLUG Web Site: http://www.mlug.org.au/ Edit your settings: http://lists.mlug.org.au