RE: nst0 attached to a raid card gives lots of errors

Russell Shaw wrote:
> Geoffrey Scott wrote:
>> Hello to everyone on this list,

>> 
>> Any suggestions would be greatly appreciated.
>> 
>> Cheers Geoff
> 
> Make sure the scsi terminator(s) are attached and working.

It's a 50 pin narrow scsi ribbon cable for an internal tape drive; there is
a big knobbly bit on the end of the cable after it attaches to the tape
drive, which I assumed was the terminator.  The other end is correctly
plugged in as, labelled to the raid card.  There doesn't appear to be any
terminators built into the tape drive (an HP surestore DAT24) So I think
it's terminated properly.......

GS