Server info
Eric Anderson <[email protected]> Thu, 30 Jan 2003 10:57:55 -0600
| Newsgroups | gmane.os.bsd.advocacy |
|---|---|
| Message-ID | <[email protected]> |
Ok, I know everyone will be asking, so here's some server stats for the
new bsdevents server:
1.066GHz VIA C3 Processor (Nothing says bang for the buck like a C3!)
150Gb total disk space (UDMA 100)
256MB DDR266 Memory
10/100Mb/s NIC
Yadda yadda yadda..
Here's the dmesg output:
FreeBSD 5.0-RELEASE #0: Thu Jan 16 22:16:53 GMT 2003
root-iWPuayUUm6/M9RVOToReAUmw1/[email protected]:/usr/obj/usr/src/sys/GENERIC
Preloaded elf kernel "/boot/kernel/kernel" at 0xc0673000.
Preloaded elf module "/boot/kernel/acpi.ko" at 0xc06730a8.
Timecounter "i8254" frequency 1193182 Hz
Timecounter "TSC" frequency 1066156472 Hz
CPU: VIA/IDT Unknown (1066.16-MHz 686-class CPU)
Origin = "CentaurHauls" Id = 0x693 Stepping = 3
Features=0x380b13d<FPU,DE,PSE,TSC,MSR,CX8,MTRR,PGE,CMOV,MMX,FXSR,SSE>
real memory = 234815488 (223 MB)
avail memory = 221167616 (210 MB)
Initializing GEOMetry subsystem
npx0: <math processor> on motherboard
npx0: INT 16 interface
acpi0: <VT9174 AWRDACPI> on motherboard
ACPI-0625: *** Info: GPE Block0 defined as GPE0 to GPE15
Using $PIR table, 5 entries at 0xc00fded0
acpi0: power button is handled as a fixed feature programming model.
Timecounter "ACPI-fast" frequency 3579545 Hz
acpi_timer0: <24-bit timer at 3.579545MHz> port 0x408-0x40b on acpi0
acpi_cpu0: <CPU> on acpi0
acpi_button0: <Power Button> on acpi0
pcib0: <ACPI Host-PCI bridge> port 0x500-0x50f,0x400-0x47f,0xcf8-0xcff
on acpi0
pci0: <ACPI PCI bus> on pcib0
agp0: <VIA Generic host to PCI bridge> mem 0xd0000000-0xd7ffffff at
device 0.0 on pci0
pcib1: <PCI-PCI bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
pci1: <display, VGA> at device 0.0 (no driver attached)
uhci0: <VIA 83C572 USB controller> port 0xd000-0xd01f irq 11 at device
16.0 on pci0
usb0: <VIA 83C572 USB controller> on uhci0
usb0: USB revision 1.0
uhub0: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
uhci1: <VIA 83C572 USB controller> port 0xd400-0xd41f irq 11 at device
16.1 on pci0
usb1: <VIA 83C572 USB controller> on uhci1
usb1: USB revision 1.0
uhub1: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1: 2 ports with 2 removable, self powered
uhci2: <VIA 83C572 USB controller> port 0xd800-0xd81f irq 12 at device
16.2 on pci0
usb2: <VIA 83C572 USB controller> on uhci2
usb2: USB revision 1.0
uhub2: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub2: 2 ports with 2 removable, self powered
pci0: <serial bus, USB> at device 16.3 (no driver attached)
isab0: <PCI-ISA bridge> at device 17.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <VIA 8235 ATA133 controller> port 0xdc00-0xdc0f at device 17.1
on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
pci0: <multimedia, audio> at device 17.5 (no driver attached)
vr0: <VIA VT6102 Rhine II 10/100BaseTX> port 0xe800-0xe8ff mem
0xde001000-0xde0010ff irq 11 at device 18.0 on pci0
vr0: Ethernet address: 00:40:63:c4:74:8b
miibus0: <MII bus> on vr0
ukphy0: <Generic IEEE 802.3u media interface> on miibus0
ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
fdc0: <Enhanced floppy controller (i82077, NE72065 or clone)> port
0x3f7,0x3f0-0x3f5 irq 6 drq 2 on acpi0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
sio0 port 0x3f8-0x3ff irq 4 on acpi0
sio0: type 16550A
sio1 port 0x2f8-0x2ff irq 3 on acpi0
sio1: type 16550A
ppc0 port 0x378-0x37f irq 7 on acpi0
ppc0: Generic chipset (EPP/NIBBLE) in COMPATIBLE mode
plip0: <PLIP network interface> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
atkbdc0: <Keyboard controller (i8042)> port 0x64,0x60 irq 1 on acpi0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
pmtimer0 on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
Timecounters tick every 10.000 msec
acpi_cpu: CPU throttling enabled, 2 steps from 100% to 50.0%
ad0: 73308MB <IBM-DTLA-307075> [148945/16/63] at ata0-master UDMA100
ad1: 73308MB <IBM-DTLA-307075> [148945/16/63] at ata0-slave UDMA100
acd0: CDROM <FX4820T> at ata1-master PIO4
Mounting root from ufs:/dev/ad0s1a
Eric