Ethernet over SPI driver for ENC424J600

Hi,

I tested the driver at Ethernet level: sending and receiving Ethernet
packets, setting and getting ESA, etc. The tests have been done on
STM3210E evaluation board (ST cortex M3 processor). Now I am trying to
perform tests with lwip stack.

First I did some initial testing with ecos3.0. Using configtool I chose
ecos3.0 repository, ST STM3210E EVAL board template and lwip_eth package
instead of default. I added my driver source and CDL files to my local
ecos3.0 repository. Everything builds fine.

Then I decided to try the lwip from the CVS. Using configtool I chose
current ecos repository (taken from CVS  on February 2. 2010), ST
STM3210E EVAL board template and lwip_eth package. I added my driver
source and CDL files to my local repository. Building library does not
yield:

    .
    .

home/iko/current_ecos/ecos/packages/net/lwip_tcpip/current/src/ecos/simple.c:72:27:
    error: netif/ppp/ppp.h: No such file or directory

/home/iko/current_ecos/ecos/packages/net/lwip_tcpip/current/src/ecos/simple.c:73:28:
    error: netif/ppp/chat.h: No such file or directory

/home/iko/current_ecos/ecos/packages/net/lwip_tcpip/current/src/ecos/simple.c:190:8:
    warning: multi-line comment
    make[1]: Leaving directory

`/home/iko/Agenda/Energ/Ramnenje/Dizajn/STM32/EVALB/ecos/test_current_ecos_build/net/lwip_tcpip/current'
    make[1]: *** [src/ecos/simple.o.d] Error 1
    make: Leaving directory

`/home/iko/Agenda/Energ/Ramnenje/Dizajn/STM32/EVALB/ecos/test_current_ecos_build'
    make: *** [build] Error 2

Any suggestions how to get on track?

Ilija Stanislevik