Re: Ethernet over SPI driver for ENC424J600

Ilija Stanislevik wrote:
> Hi,
> 
> I tested the driver at Ethernet level: sending and receiving Ethernet
> packets, setting and getting ESA, etc. The tests have been done on
> STM3210E evaluation board (ST cortex M3 processor). Now I am trying to
> perform tests with lwip stack.
> 
> First I did some initial testing with ecos3.0. Using configtool I chose
> ecos3.0 repository, ST STM3210E EVAL board template and lwip_eth package
> instead of default. I added my driver source and CDL files to my local
> ecos3.0 repository. Everything builds fine.
> 
> Then I decided to try the lwip from the CVS. Using configtool I chose
> current ecos repository (taken from CVS  on February 2. 2010), ST
> STM3210E EVAL board template and lwip_eth package. I added my driver
> source and CDL files to my local repository. Building library does not
> yield:
> 
>     .
>     .
> 
> home/iko/current_ecos/ecos/packages/net/lwip_tcpip/current/src/ecos/simple.c:72:27:
>     error: netif/ppp/ppp.h: No such file or directory
> 
> /home/iko/current_ecos/ecos/packages/net/lwip_tcpip/current/src/ecos/simple.c:73:28:
>     error: netif/ppp/chat.h: No such file or directory
> 
> /home/iko/current_ecos/ecos/packages/net/lwip_tcpip/current/src/ecos/simple.c:190:8:
>     warning: multi-line comment
>     make[1]: Leaving directory
> 
> `/home/iko/Agenda/Energ/Ramnenje/Dizajn/STM32/EVALB/ecos/test_current_ecos_build/net/lwip_tcpip/current'
>     make[1]: *** [src/ecos/simple.o.d] Error 1
>     make: Leaving directory
> 
> `/home/iko/Agenda/Energ/Ramnenje/Dizajn/STM32/EVALB/ecos/test_current_ecos_build'
>     make: *** [build] Error 2
> 
> Any suggestions how to get on track?

Hmm, I just did the following, using the latest CVS repository:

ecosconfig new stm3210e_eval lwip_eth
ecosconfig tree
make
make -C net/lwip_tcpip/current/ tests

Everything builds, as far as I can see. Try to recreate your tree, or 
start with a clean configuration again.

Simon