Re: RPI5 serial console? - Re: Raspbery Pi support (release notes/wiki page) update? (RPI5)
Dennis Clarke <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.arm |
|---|---|
| Organization | GENUNIX |
| Message-ID | <[email protected]> |
On 1/14/25 08:08, Klaus Küchemann wrote: > > >> Am 14.01.2025 um 14:02 schrieb Dennis Clarke <[email protected]>: >> >> On 1/14/25 08:00, Klaus Küchemann wrote: >>>> Am 14.01.2025 um 11:47 schrieb Ronald Klop <[email protected]>: >>>> >>>> Hi, >>>> >>>> Thanks for all this info. >>>> I received my RPI5 and noticed that the default serial/UART is not on GPIO anymore, but via a dedicated 3-pin JST HS (?) connector. >>>> >>> dtoverlay=uart0 >> >> I have no idea what that means. Something in /boot/loader.conf or >> in /etc/rc.conf or some other magic? >> >> -- >> -- >> Dennis Clarke >> RISC-V/SPARC/PPC/ARM/CISC >> UNIX and Linux spoken >> >> > > > in config.txt, > of course you’ll need the matching overlay(from the firmware) in place > > Regards > K. You are speaking of deep undocumented magic. -- -- Dennis Clarke RISC-V/SPARC/PPC/ARM/CISC UNIX and Linux spoken