Re: RPI5 serial console? - Re: Raspbery Pi support (release notes/wiki page) update? (RPI5)
Paul Mather <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.arm |
|---|---|
| Message-ID | <[email protected]> |
On Jan 15, 2025, at 9:16 am, Dennis Clarke <[email protected]> wrote: > On 1/14/25 08:08, Klaus Küchemann wrote: >>> Am 14.01.2025 um 14:02 schrieb Dennis Clarke <[email protected]>: >>> >>> On 1/14/25 08:00, Klaus Küchemann wrote: >>>>> Am 14.01.2025 um 11:47 schrieb Ronald Klop <[email protected]>: >>>>> >>>>> Hi, >>>>> >>>>> Thanks for all this info. >>>>> I received my RPI5 and noticed that the default serial/UART is not on GPIO anymore, but via a dedicated 3-pin JST HS (?) connector. >>>>> >>>> dtoverlay=uart0 >>> >>> I have no idea what that means. Something in /boot/loader.conf or >>> in /etc/rc.conf or some other magic? >>> >>> -- >>> -- >>> Dennis Clarke >>> RISC-V/SPARC/PPC/ARM/CISC >>> UNIX and Linux spoken >>> >>> >> in config.txt, >> of course you’ll need the matching overlay(from the firmware) in place >> Regards >> K. > > > You are speaking of deep undocumented magic. Not really. In the Raspberry Pi ecosystem, config.txt is well-documented, e.g., https://www.raspberrypi.com/documentation/computers/config_txt.html Cheers, Paul.