Re: 400/800 card
"Hidetoshi Shimokawa" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.firewire |
|---|---|
| Message-ID | <[email protected]> |
try 'fwcontrol -p'. On Wed, Jun 11, 2008 at 10:07 PM, Sean Bruno <[email protected]> wrote: > Hidetoshi Shimokawa wrote: >> >> On Wed, Jun 11, 2008 at 10:56 AM, Sean Bruno <[email protected]> wrote: >> >>> >>> I have a 400/800 card installed in my RELENG_7 box that has one 800 >>> connector and two 400 connectors on it. Looking over the system, I >>> wonder >>> if the card is working correctly when I attach a S400 device to it: >>> >>> [sean@home-test ~]$ sudo fwcontrol -t >>> crc_len: 3 generation:1 node_count:1 sid_count:1 >>> id link gap_cnt speed delay cIRM power port0 port1 port2 ini more >>> 00 1 63 S800 0 1 -1W - - - 1 0 >>> >> >> The phy layer doesn't seem to recognize the S400 device. >> It seem to be a hardware problem. >> Are your cable and connector o.k.? >> Did a bus reset occur when you attached the device? >> > > The output of fwcontrol was generated with no attached device. I thought I > would see > a report of both the S400 and S800 capable ports in the output. > > Sean > > -- /\ Hidetoshi Shimokawa \/ [email protected] _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-firewire To unsubscribe, send any mail to "[email protected]"