Re: 400/800 card
Sean Bruno <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.firewire |
|---|---|
| Message-ID | <[email protected]> |
Hidetoshi Shimokawa wrote: > try 'fwcontrol -p'. > > > Interesting. I can't discern from this output, which port actually has the S400 device connected to it. That seems to output the following: === base register === 0x03 0x05 0xe3 0xe2 0xc4 0x03 0x10 0x20 Physical_ID:0 R:1 CPS:1 RHB:0 IBR:0 Gap_Count:5 Extended:7 Num_Ports:3 PHY_Speed:7 Delay:2 LCtrl:1 C:1 Jitter:0 Pwr_Class:4 WDIE:0 ISBR:0 CTOI:0 CPSI:0 STOI:0 PEI:0 EAA:1 EMC:1 Max_Legacy_SPD:0 BLINK:1 Bridge:0 Page_Select:1 Port_Select0 === page 0 port 0 === 0xf8 0x60 0x3b 0x00 0x00 0x00 0x00 0x00 Astat:3 BStat:3 Ch:1 Con:0 RXOK:0 Dis:0 Negotiated_speed:3 PIE:0 Fault:0 Stanby_fault:0 Disscrm:0 B_Only:0 DC_connected:0 Max_port_speed:3 LPP:1 Cable_speed:3 Connection_unreliable:0 Beta_mode:0 Port_error:0x0 Loop_disable:0 In_standby:0 Hard_disable:0 === page 0 port 1 === 0xf8 0x60 0x3b 0x00 0x00 0x00 0x00 0x00 Astat:3 BStat:3 Ch:1 Con:0 RXOK:0 Dis:0 Negotiated_speed:3 PIE:0 Fault:0 Stanby_fault:0 Disscrm:0 B_Only:0 DC_connected:0 Max_port_speed:3 LPP:1 Cable_speed:3 Connection_unreliable:0 Beta_mode:0 Port_error:0x0 Loop_disable:0 In_standby:0 Hard_disable:0 === page 0 port 2 === 0xf8 0x60 0x3b 0x00 0x00 0x00 0x00 0x00 Astat:3 BStat:3 Ch:1 Con:0 RXOK:0 Dis:0 Negotiated_speed:3 PIE:0 Fault:0 Stanby_fault:0 Disscrm:0 B_Only:0 DC_connected:0 Max_port_speed:3 LPP:1 Cable_speed:3 Connection_unreliable:0 Beta_mode:0 Port_error:0x0 Loop_disable:0 In_standby:0 Hard_disable:0 === page 1 === 0x02 0x00 0x08 0x00 0x28 0x83 0x13 0x04 Compliance:2 Vendor_ID:0x080028 Product_ID:0x831304 _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-firewire To unsubscribe, send any mail to "[email protected]"