Re: sbp_targ errors with windows initiators

> Allrighty, I seem to have found my issue(I can't believe that it's 
> only affecting sbp_targ however).
>
> It seems that fwohci_intr_body() invoked from the interrupt handler at 
> fwohci_pci.c::fwohci_pci_attach() was being set with INTR_MPSAFE.  It 
> definitely was not MPSAFE and needed Giant locked before it could 
> start another interrupt.  Strange that this hasn't been seen in the wild.
>
> small diff attached:
> [sbruno@desdemona 
> ~/work/branches/miralink.FreeBSD.6/src/sys/dev/firewire]$ svn diff
> Index: fwohci_pci.c
> ===================================================================
> --- fwohci_pci.c        (revision 5496)
> +++ fwohci_pci.c        (working copy)
> @@ -336,7 +336,7 @@
>
>        err = bus_setup_intr(self, sc->irq_res,
> #if FWOHCI_TASKQUEUE
> -                       INTR_TYPE_NET | INTR_MPSAFE,
> +                       INTR_TYPE_NET,
> #else
>                        INTR_TYPE_NET,
> #endif
>
>
This failed after a few more iterations in the same way.  I enabled 
"OHCI_DEBUG" so I can see what events are being processed in 
fwohci_intr_body().

It looks like the following is the first event that is seen:
fwohci0: INTERRUPT < CYC_64SECOND CYC_START BUS_RESET DMA_PRRQ > 
0x00320010, 0x81430133

The DMA_PRRQ seems to cause the firewire layer to end up calling 
sbp_targ_recv().  The next event to occur is:
fwohci0: INTERRUPT < CYC_LOST CYC_START SID DMA_PRRQ > 0x00510010, 
0x81010133

This causes us to properly probe/explore the firewire bus and setup the 
node ids.  Unfortuneatly, the first event causes an sbp_targ failure as 
it is not processed correctly:
fwohci0: INTERRUPT < CYC_64SECOND CYC_START BUS_RESET DMA_PRRQ > 
0x00320010, 0x81430133
fwohci0: BUS reset
sbp_targ_recv: cannot resolve nodeid=0
sbp_targ_recv: rtcode = 6 lo == 0x0
fwohci0: INTERRUPT < CYC_LOST CYC_START SID DMA_PRRQ > 0x00510010, 
0x81010133
fwohci0: node_id=0xc800ffc1, gen=4, CYCLEMASTER mode
firewire0: 2 nodes, maxhop <= 1, cable IRM = 1 (me)
firewire0: bus manager 1 (me)

I guess that the BUS_RESET OHCI event needs to do something different 
that I don't fully understand.  Any ideas?

-- 
Sean Bruno
MiraLink Corporation
6015 NE 80th Ave, Ste 100
Portland, OR 97218
Phone 503-621-5143
Fax 503-621-5199

_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-firewire
To unsubscribe, send any mail to "[email protected]"