[RELENG_7] SBP Drives not recognized

In an effort to test my sbp_targ modifications, I fired up a FreeBSD 7 
initiator, and cvsup'd to RELENG_7. I then connected an external SBP2 
device that I got off of NewEgg. 

I was surprised to see it not work when I plugged it in:
Jun 19 11:30:01 home-test kernel: fwohci0: BUS reset
Jun 19 11:30:01 home-test kernel: fwohci0: node_id=0xc800ffc1, gen=6, 
CYCLEMASTER mode
Jun 19 11:30:01 home-test kernel: sbp_post_busreset
Jun 19 11:30:01 home-test kernel: firewire0: 2 nodes, maxhop <= 1, cable 
IRM = 1 (me)
Jun 19 11:30:01 home-test kernel: fwohci0: fw_set_bus_manager: 1->1 (loop=0)
Jun 19 11:30:01 home-test kernel: firewire0: bus manager 1 (me)
Jun 19 11:30:01 home-test kernel: send phy_config root_node=1 gap_count=5
Jun 19 11:30:01 home-test kernel: fwohci0: start AT DMA status=11
Jun 19 11:30:02 home-test kernel: firewire0: New S800 device 
ID:0001d27ceea502b8
Jun 19 11:30:02 home-test kernel: fwohci0: txd err= 3 miss Ack err
Jun 19 11:30:02 home-test kernel: fw_explore: node 2, err = -1
Jun 19 11:30:02 home-test kernel: fwohci0: txd err= 3 miss Ack err
Jun 19 11:30:02 home-test kernel: fw_explore: node 2, err = -1
Jun 19 11:30:02 home-test kernel: fwohci0: txd err= 3 miss Ack err
Jun 19 11:30:02 home-test kernel: fw_explore: node 2, err = -1
Jun 19 11:30:02 home-test kernel: bus_explore done
Jun 19 11:30:02 home-test kernel: sbp_post_explore (sbp_cold=0)
Jun 19 11:30:02 home-test kernel: sbp_post_explore: EUI:0001d27ceea502b8 
not attached, state=3.



This looks an awful lot like my issues with sbp_targ from previous 
emails and may indicate a more serious failure in fwohci.c or firewire.c

Or, it may indicate that I have no idea what I am doing.  :)

This SBP-2 device is a external 2 disk enclosure with an Oxford 
Semicondoctor F/W controller.  It seems to work just fine with linux and 
windows.

[sean@home-test ~]$ sudo fwcontrol -t
crc_len: 4 generation:8 node_count:2 sid_count:2
id link gap_cnt speed delay cIRM power port0 port1 port2 ini more
00    1       5  S800     0    0   -1W     -     -     P   0    0
01    1       5  S800     0    1   -1W     C     -     -   1    0

[sean@home-test ~]$ sudo fwcontrol -p
=== base register ===
0x07 0x85 0xe3 0xe2 0xc4 0x03 0x50 0x00
Physical_ID:1  R:1  CPS:1
RHB:1  IBR:0  Gap_Count:5
Extended:7 Num_Ports:3
PHY_Speed:7 Delay:2
LCtrl:1 C:1 Jitter:0 Pwr_Class:4
WDIE:0 ISBR:0 CTOI:0 CPSI:0 STOI:0 PEI:0 EAA:1 EMC:1
Max_Legacy_SPD:2 BLINK:1 Bridge:0
Page_Select:0 Port_Select0

=== page 0 port 0 ===
0xfe 0x40 0xbb 0x00 0x00 0x00 0x00 0x00
Astat:3 BStat:3 Ch:1 Con:1 RXOK:1 Dis:0
Negotiated_speed:2 PIE:0 Fault:0 Stanby_fault:0 Disscrm:0 B_Only:0
DC_connected:1 Max_port_speed:3 LPP:1 Cable_speed:3
Connection_unreliable:0 Beta_mode:0
Port_error:0x0
Loop_disable:0 In_standby:0 Hard_disable:0

=== page 0 port 1 ===
0xf8 0x60 0x3b 0x00 0x00 0x00 0x00 0x00
Astat:3 BStat:3 Ch:1 Con:0 RXOK:0 Dis:0
Negotiated_speed:3 PIE:0 Fault:0 Stanby_fault:0 Disscrm:0 B_Only:0
DC_connected:0 Max_port_speed:3 LPP:1 Cable_speed:3
Connection_unreliable:0 Beta_mode:0
Port_error:0x0
Loop_disable:0 In_standby:0 Hard_disable:0

=== page 0 port 2 ===
0xf8 0x60 0x3b 0x00 0x00 0x00 0x00 0x00
Astat:3 BStat:3 Ch:1 Con:0 RXOK:0 Dis:0
Negotiated_speed:3 PIE:0 Fault:0 Stanby_fault:0 Disscrm:0 B_Only:0
DC_connected:0 Max_port_speed:3 LPP:1 Cable_speed:3
Connection_unreliable:0 Beta_mode:0
Port_error:0x0
Loop_disable:0 In_standby:0 Hard_disable:0

=== page 1 ===
0x02 0x00 0x08 0x00 0x28 0x83 0x13 0x04
Compliance:2
Vendor_ID:0x080028
Product_ID:0x831304

_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-firewire
To unsubscribe, send any mail to "[email protected]"