Re: multiple pccard adapters

This is very strange. pcic1 is disabled, yet it is in the bootup
messages. pcic0 is not. If I enable pcic1 I still get the same
message.

Jun 23 23:16:00 foo /kernel: pcic1: <Vadem 469> at port 0x3e0 iomem 0xd0000 on 
isa0
Jun 23 23:16:00 foo /kernel: pcic1: Polling mode
Jun 23 23:16:00 foo /kernel: pccard1: <PC Card bus (classic)> on pcic1
Jun 23 23:16:00 foo /kernel: pccard2: <PC Card bus (classic)> on pcic1

...

Jun 23 23:16:18 foo pccardd[49]: No free configuration for card Lucent 
Technologies


On Sunday 23 June 2002 10:23 pm, you wrote:
> Aaron,
>
> You can enable pcic1 without rebuilding your kernel.
>
> update /boot/loader.conf with
>
> userconfig_script_load="YES"
>
> and /boot/kernel.conf with
>
> en pcic1
> q
>
> [The userconfig solution is generalizable to the various devices (with
> unit numbers) in the kernel, with at least the following commands:
>
>   di sio1            (disable)
>   en pcic1           (enable)
>   po pcm0 0x530      (set port)
>   ir pcic0 9         (set IRQ)
>   dr pcm0 1          (set DRQ)
>   iom pcic0 0xd8000  (set iomem)
>   ios ata2 16        (set iosize)
>   f pcm0 0x10        (set flags)
>   ls                 (list all configurable devices)
>   q                  (last line)
>
> This is very handy on those older machines where it takes a long time
> to rebuild the kernel.  Try boot -c to get the whole picture.]
>
> Greg
>
> -----Original Message-----
>
> >Sorry... 4.6-stable
> >
> >the standard pccard settings in the
> >kernel conf file:
> >
> >device          card
> >device          pcic0   at isa? irq 0 port 0x3e0 iomem 0xd0000
> >device          pcic1   at isa? irq 0 port 0x3e2 iomem 0xd4000 disable
> >
> >l8r
> >Aaron
> >
> >On Sunday 23 June 2002 10:07 pm, you wrote:
> >> Aaron,
> >>
> >> What version of FreeBSD are you using?  What settings?
> >>
> >> Greg
> >>
> >> -----Original Message-----
> >>
> >> >I'm trying to figure out how to put multiple pccard
> >> >adapters for multiple wireless nics into a system.
> >> >I have one isa adapter and one pci adapter. When
> >> >I insert the second wireless nics I get an error
> >> >saying no free configuration is available. Do I need
> >> >to setup anything special in the kernel configuration
> >> >to allow multiple card devices?
> >> >
> >> >l8r
> >> >Aaron
> >> >
> >> >
> >> >
> >> >To Unsubscribe: send mail to [email protected]
> >> >with "unsubscribe freebsd-mobile" in the body of the message
> >
> >To Unsubscribe: send mail to [email protected]
> >with "unsubscribe freebsd-mobile" in the body of the message


To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message