pcmcia flash card problems after 4.6-S

Since upgrading from 4.4-STABLE (around Oct 2001) to 4.6-STABLE 
(30th June 2002), I can no longer get my Kodak Flash Card to work.
Its a 64Mb ATA compatible card, and worked perfectly in 4.4.
Pccardd now gives a "driver allocation failed: Device not configured"

Below is output from "dmesg -a" with the pccardd output at the
end. (I enabled "debuglevel 9" in /etc/pccard.conf).  I also tried
adding an entry in pccard.conf for the card that exactly matched the
card's identification output - the entry in /etc/defaults/pccard.conf
didn't seem to be matched.  It made no difference in either case.

The hardware is a Toshiba Portege 3440CT.

Any pointers, things to try, etc, would be greatly appreciated.

--
Richard Perini                                       Internet:  [email protected]
Corinthian Engineering Pty Ltd                       PHONE:   +61 2 9906 7866
Sydney, Australia                                    FAX:     +61 2 9906 2464


Copyright (c) 1992-2002 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
	The Regents of the University of California. All rights reserved.
FreeBSD 4.6-STABLE #1: Sun Jun 30 14:19:46 EST 2002
    [email protected]:/usr/src/sys/compile/LOCAL
Timecounter "i8254"  frequency 1193182 Hz
CPU: Pentium III/Pentium III Xeon/Celeron (500.02-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0x681  Stepping = 1
  Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE>
real memory  = 134086656 (130944K bytes)
avail memory = 126799872 (123828K bytes)
Preloaded elf kernel "kernel" at 0xc03b0000.
Pentium Pro MTRR support enabled
md0: Malloc disk
Using $PIR table, 9 entries at 0xc00f0190
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Intel 82443MX host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
pcm0: <Intel 443MX> port 0xfcc0-0xfcff,0xfd00-0xfdff irq 11 at device 0.1 on pci0
pci0: <unknown card> (vendor=0x0000, dev=0x0000) at 0.2
pci0: <unknown card> (vendor=0x11c1, dev=0x0441) at 2.0 irq 11
pci0: <S3 model 8c12 graphics accelerator> at 4.0 irq 11
isab0: <Intel 82443MX PCI to ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel PIIX4 ATA33 controller> port 0xf870-0xf87f at device 7.1 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
uhci0: <Intel 82443MX USB controller> port 0xf840-0xf85f irq 11 at device 7.2 on pci0
usb0: <Intel 82443MX USB controller> on uhci0
usb0: USB revision 1.0
uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
chip1: <Intel 82443MX Power management controller> port 0xfe70-0xfe7f at device 7.3 on pci0
pci0: <unknown card> (vendor=0x1179, dev=0x0d01) at 9.0 irq 11
pci_cfgintr_linked: linked (60) to hard-routed irq 11
pci_cfgintr: 0:11 INTA routed to irq 11
pcic0: <Toshiba ToPIC100 PCI-CardBus Bridge> irq 11 at device 11.0 on pci0
pcic0: PCI Memory allocated: 0x44000000
pccard0: <PC Card bus (classic)> on pcic0
pci_cfgintr_linked: linked (61) to hard-routed irq 11
pci_cfgintr: 0:11 INTB routed to irq 11
pcic1: <Toshiba ToPIC100 PCI-CardBus Bridge> irq 11 at device 11.1 on pci0
pcic1: PCI Memory allocated: 0x44001000
pccard1: <PC Card bus (classic)> on pcic1
orm0: <Option ROM> at iomem 0xc0000-0xcbfff on isa0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model IntelliMouse, device ID 3
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode
plip0: <PLIP network interface> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
pccard: card inserted, slot 1
pccard: card removed, slot 1
ad0: 5729MB <TOSHIBA MK6014MAP> [12416/15/63] at ata0-master UDMA33
Mounting root from ufs:/dev/ad0s2a
pccard: card inserted, slot 1
swapon: adding /dev/ad0s2b as swap device
Automatic boot in progress...
/dev/ad0s2a: 
FILESYSTEM CLEAN; SKIPPING CHECKS
/dev/ad0s2a: 
clean, 5725 free 
(237 frags, 686 blocks, 0.5% fragmentation)
/dev/ad0s2e: 
FILESYSTEM CLEAN; SKIPPING CHECKS
/dev/ad0s2e: 
clean, 1660090 free 
(11258 frags, 206104 blocks, 0.3% fragmentation)
Warning: Block size restricts cylinders per group to 104.
Setup PC-CARD:
 memory
 beep
 pccardd
.
Doing initial network setup:
 hostname
.
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384
	inet 127.0.0.1 netmask 0xff000000 
Additional routing options:
 TCP keepalive=YES
.
Routing daemons:
.
Additional daemons:
 syslogd
  syslogd: /var/log/auth.log: No such file or directory
.
Doing additional network setup:
 ntpdate
 ntpd
.
Starting final network daemons:
.
ELF ldconfig path: /usr/lib /usr/lib/compat /usr/X11R6/lib /usr/local/lib
a.out ldconfig path: /usr/lib/aout /usr/lib/compat/aout /usr/X11R6/lib/aout
Starting standard daemons:
 inetd
 cron
 usbd
 sendmail-submit
 sendmail-clientmqueue
.
Initial rc.i386 initialization:
.
Configuring syscons:
 blanktime
 moused
.
Additional ABI support:
 linux
Jul  7 17:30:45 meson pccardd[47]: Card "3Com"("3C574-TX Fast EtherLink PC Card") [A] [001] matched "3Com" ("3C574-TX Fast EtherLink PC Card") [(null)] [(null)] 
Jul  7 17:30:45 meson pccardd[47]: Using I/O addr 0x240, size 32 
Jul  7 17:30:45 meson pccardd[47]: Setting config reg at offs 0x10000 to 0x41, Reset time = 50 ms 
.
Local package initialization:
 Modula-3
.
Additional TCP options:
.

Sun Jul  7 17:30:47 EST 2002
Jul  7 17:30:50 meson pccardd[47]: Assigning I/O window 0, start 0x240, size 0x20 flags 0x7 
Jul  7 17:30:50 meson pccardd[47]: Assign ep0, io 0x240-0x25f, mem 0x0, 0 bytes, irq 11, flags 1 
ep0: <3Com 3C574> at port 0x240-0x25f irq 11 flags 0x1 slot 1 on pccard1
ep0: Ethernet address 00:10:4b:5f:2d:14
Jul  7 17:30:50 meson pccardd[47]: ep0: 3Com (3C574-TX Fast EtherLink PC Card) inserted.
Jul  7 17:30:55 meson pccardd[47]: pccardd started
Jul  7 17:31:02 meson ssu: user rpp exec'ing netgo
pccard: card inserted, slot 0
Jul  7 17:31:27 meson pccardd[47]: Card "KODAK Picture Card       "("KODAK  ") [V4X01] [(null)] matched "KODAK Picture Card       " ("KODAK  ") [(null)] [(null)] 
Jul  7 17:31:27 meson pccardd[47]: Using I/O addr 0x170, size 8 
Jul  7 17:31:27 meson pccardd[47]: Using I/O addr 0x376, size 2 
Jul  7 17:31:27 meson pccardd[47]: Setting config reg at offs 0x200 to 0x43, Reset time = 50 ms 
Jul  7 17:31:32 meson pccardd[47]: Assigning I/O window 0, start 0x170, size 0x8 flags 0x7 
Jul  7 17:31:32 meson pccardd[47]: Assigning I/O window 1, start 0x376, size 0x2 flags 0x7 
Jul  7 17:31:32 meson pccardd[47]: Assign ata0, io 0x170-0x177, mem 0x0, 0 bytes, irq 11, flags 0 
Jul  7 17:31:32 meson pccardd[47]: driver allocation failed for KODAK Picture Card       (KODAK  ): Device not configured

To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message