Re: [KISMET] call for help - bsd commands
Tony Saign <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
Mike Kershaw <[email protected]> wrote .. > I'm unifying the Kismet monitor scripts into one (kismet_monitor) that > uses > a new config option (card=) to enable monitor mode on cards. This should > make things less confusing. However, not being a BSD guy, I need the > control commands for BSD. I know ancontrol -o 1 and -m 7 enable monitor > for Cisco cards, but I need the same for Prism2 and for Orinoco. For the > latter, I also need to know how to set the channel to monitor. > > If anyone knows, please drop me an email... I don't believe the driver "wi" has this capabilities? Corrections welcome! I use the utility prism2ctl that comes with bsd-airtools to set up monitor mode. Using Kismet under FreeBSD in monitor mode creates a lot of bogus detections from the local wi interface in monitor mode as well. But still does detect other wireless traffic. -Tony > > -m > > -- > Censorship, like charity, should begin at home, but > unlike charity, it should end there. -- Clare Boothe Luce