ath countrycode
Jiri Mikulas <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
Hello I have ATH cards Wistron CM9 (AR5213), I want to set correct countrycode to use correct channels (ETSI) (channels 1-13 on 11g, channels 100-140 on 11a) but it's "disabled' osika:/# sysctl -a dev.ath.0.countrycode=203 sysctl: oid 'dev.ath.0.countrycode' is read only On most HW wireles AP I can switch country (for example COMPEX WPE54AG-5GHz), on NetBSD and Linux I can set it too (according to this article http://www.fehu.org/atheros.html ) so I'm little bit suprised, that it's 'forbiden' on Freebsd I have FreeBSD 6.0-STABLE #1: Thu Jan 19 10:40:33 CET 2006 dev.ath.0.countrycode: 0 dev.ath.0.regdomain: 0 hw.ath.hal.version: 0.9.14.9 ath0: <Atheros 5212> mem 0xff920000-0xff92ffff irq 17 at device 2.0 on pci1 ath0: Ethernet address: 00:0b:6b:35:46:d7 ath0: mac 5.9 phy 4.3 radio 3.6 osika:/# ifconfig ath0 list chan Channel 1 : 2412 Mhz 11g Channel 48 : 5240 Mhz 11a Channel 2 : 2417 Mhz 11g Channel 50 : 5250 Mhz 11a Turbo Channel 3 : 2422 Mhz 11g Channel 52 : 5260 Mhz 11a Channel 4 : 2427 Mhz 11g Channel 56 : 5280 Mhz 11a Channel 5 : 2432 Mhz 11g Channel 58 : 5290 Mhz 11a Turbo Channel 6 : 2437 Mhz 11g Channel 60 : 5300 Mhz 11a Channel 7 : 2442 Mhz 11g Channel 64 : 5320 Mhz 11a Channel 8 : 2447 Mhz 11g Channel 149 : 5745 Mhz 11a Channel 9 : 2452 Mhz 11g Channel 152 : 5760 Mhz 11a Turbo Channel 10 : 2457 Mhz 11g Channel 153 : 5765 Mhz 11a Channel 11 : 2462 Mhz 11g Channel 157 : 5785 Mhz 11a Channel 36 : 5180 Mhz 11a Channel 160 : 5800 Mhz 11a Turbo Channel 40 : 5200 Mhz 11a Channel 161 : 5805 Mhz 11a Channel 42 : 5210 Mhz 11a Turbo Channel 165 : 5825 Mhz 11a Channel 44 : 5220 Mhz 11a Is there any way to switch countrycode on FBSD please ? Thanks for reply Jiri _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"