Re: USR 2410 support
Jordi YC <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
Dan,
I have this card working on -STABLE without problems.
If you have upgrade your system from an older version, I would suggest
you to use mergemaster or check /etc/defaults/pccard.conf for this entry
# U.S. Robotics Wireless Card 2410
card "U. S. Robotics" "IEEE 802.11b PC-CARD"
config auto "wi" ?
insert /etc/pccard_ether $device start
remove /etc/pccard_ether $device stop
I would also suggest to upgrade the firmware version with the flash
utilities from other vendors since USRobotics does not provide them (AKAIK)
Check the archives for PrismII chips.....
HTH
Dan Pelleg wrote:
>I'm trying to use the ultra-cheap USR 2410 wireless card on -STABLE. The
>4.6 release notes say it's supported with the wi driver. However when I
>insert it I get:
>
>pccardd[68]: No card in database for "U.S. Robotics"("IEEE 802.11b PC-CARD")
>
>What did I forget?
>
>--
> Dan Pelleg
>
>
>
>
>
To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message