RE: USR 2410 support

Looks like a 'typo' ?? extra space in the file after U. ??

Check it out, and let me know, as I have one of these cheapo's on the
way as well.

-Tony

}-----Original Message-----
}From: [email protected] 
}[mailto:[email protected]] On Behalf Of Jordi YC
}Sent: Thursday, July 18, 2002 14:15
}To: Dan Pelleg
}Cc: [email protected]
}Subject: Re: USR 2410 support
}
}
}Dan,
}
}I have this card working on -STABLE without problems.
}
}If you have upgrade your system from an older version, I would suggest 
}you to use mergemaster or check /etc/defaults/pccard.conf for 
}this entry
}
}# U.S. Robotics Wireless Card 2410
}card "U. S. Robotics" "IEEE 802.11b PC-CARD"
}        config  auto "wi" ?
}        insert  /etc/pccard_ether $device start
}        remove  /etc/pccard_ether $device stop
}
}I would also suggest to upgrade the firmware version with the flash 
}utilities from other vendors since USRobotics does not provide 
}them (AKAIK)
}Check the archives for PrismII chips.....
}
}HTH
}
}
}Dan Pelleg wrote:
}
}>I'm trying to use the ultra-cheap USR 2410 wireless card on 
}-STABLE. The
}>4.6 release notes say it's supported with the wi driver. 
}However when I
}>insert it I get:
}>
}>pccardd[68]: No card in database for "U.S. Robotics"("IEEE 
}802.11b PC-CARD")
}>
}>What did I forget?
}>
}>--
}> Dan Pelleg
}>
}>
}>
}>  
}>
}
}
}
}To Unsubscribe: send mail to [email protected]
}with "unsubscribe freebsd-mobile" in the body of the message
}


To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message