Re: Route #3 - USB 802.11 a/b/g
Sam Leffler <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
Jim Stapleton wrote: > On 10/7/06, Lars Engels <[email protected]> wrote: >> On Fri, Oct 06, 2006 at 07:22:50PM -0400, Jim Stapleton wrote: >> > OK, that's interesting, I tried, that, and got this: >> > >> > ural0: >> flags=108843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST,NEEDSGIANT> mtu >> > 1500 >> > inet6 fe80::215:e9ff:fe2d:72c3%ural0 prefixlen 64 scopeid 0x4 >> > inet 192.168.1.84 netmask 0xffffff00 broadcast 49.49.253.171 >> > ether 00:15:e9:2d:72:c3 >> > media: IEEE 802.11 Wireless Ethernet OFDM/54Mbps (OFDM/54Mbps) >> > status: no carrier >> > ssid mine channel 6 >> > authmode OPEN privacy ON deftxkey 1 txpowmax 100 protmode CTS >> > bintval 100 >> > >> > I've tried replacing wep with wepkey, I've tried weptxkey 1 to 4, no >> > luck on any of those. >> > >> > Any other suggestions? >> > >> >> Perhaps the authmode needs to be set to SHARED? >> > > That didn't work either -- I also tried 8021x and wpa. Both gave me an > error: > ifconfig: SIOCS80211: invalid argument "status: no carrier" means you are not associated to the ap. When the reason is not obvious I usually do this: wlandebug -i ural0 scan+auth+assoc before bringing the interface up w/ ifconfig. The console msgs should tell you what's going on. I don't recall if "ifconfig ural0 debug" will give you similar info. Of course it'd be better if the failure code for the last auth/assoc attempt was reported by ifconfig in this situation (I think it's available by ioctl but can't recall--if not it's easy to add and has been done for other systems). Sam PS. wlandebug is in src/tools/tools/net80211. _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"