Re: Route #3 - USB 802.11 a/b/g
"Jim Stapleton" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
On 10/8/06, Sam Leffler <[email protected]> wrote: > Jim Stapleton wrote: > > On 10/7/06, Lars Engels <[email protected]> wrote: > >> On Fri, Oct 06, 2006 at 07:22:50PM -0400, Jim Stapleton wrote: > >> > OK, that's interesting, I tried, that, and got this: > >> > > >> > ural0: > >> flags=108843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST,NEEDSGIANT> mtu > >> > 1500 > >> > inet6 fe80::215:e9ff:fe2d:72c3%ural0 prefixlen 64 scopeid 0x4 > >> > inet 192.168.1.84 netmask 0xffffff00 broadcast 49.49.253.171 > >> > ether 00:15:e9:2d:72:c3 > >> > media: IEEE 802.11 Wireless Ethernet OFDM/54Mbps (OFDM/54Mbps) > >> > status: no carrier > >> > ssid mine channel 6 > >> > authmode OPEN privacy ON deftxkey 1 txpowmax 100 protmode CTS > >> > bintval 100 > >> > > >> > I've tried replacing wep with wepkey, I've tried weptxkey 1 to 4, no > >> > luck on any of those. > >> > > >> > Any other suggestions? > >> > > >> > >> Perhaps the authmode needs to be set to SHARED? > >> > > > > That didn't work either -- I also tried 8021x and wpa. Both gave me an > > error: > > ifconfig: SIOCS80211: invalid argument > > "status: no carrier" means you are not associated to the ap. When the > reason is not obvious I usually do this: > > wlandebug -i ural0 scan+auth+assoc > > before bringing the interface up w/ ifconfig. The console msgs should > tell you what's going on. I don't recall if "ifconfig ural0 debug" will > give you similar info. > > Of course it'd be better if the failure code for the last auth/assoc > attempt was reported by ifconfig in this situation (I think it's > available by ioctl but can't recall--if not it's easy to add and has > been done for other systems). > > Sam > > PS. wlandebug is in src/tools/tools/net80211. > well, it gave me something that is probably useful - but I've no idea how to use it. sjss@aragorn 16:17:27 (0) ~ > sudo wlandebug -i ural0 scan+auth+assoc net.wlan.1.debug: 0x0 => 0xe00000<assoc,auth,scan> there was no other output. Nothing appeared in dmesg thanks, -Jim Stapleton _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"