Re: Route #3 - USB 802.11 a/b/g
"Yuri Lukin" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
Jim Stapleton wrote .. > On 10/8/06, Sam Leffler <[email protected]> wrote: > > > > "status: no carrier" means you are not associated to the ap. When the > > reason is not obvious I usually do this: > > > > wlandebug -i ural0 scan+auth+assoc > > > > before bringing the interface up w/ ifconfig. The console msgs should > > tell you what's going on. I don't recall if "ifconfig ural0 debug" will > > give you similar info. > > > > Of course it'd be better if the failure code for the last auth/assoc > > attempt was reported by ifconfig in this situation (I think it's > > available by ioctl but can't recall--if not it's easy to add and has > > been done for other systems). > > > > Sam > > > > PS. wlandebug is in src/tools/tools/net80211. > > > > > well, it gave me something that is probably useful - but I've no idea > how to use it. > > sjss@aragorn 16:17:27 (0) ~ > sudo wlandebug -i ural0 scan+auth+assoc > net.wlan.1.debug: 0x0 => 0xe00000<assoc,auth,scan> > > > there was no other output. Nothing appeared in dmesg > > thanks, > -Jim Stapleton Did you bounce the interface via ifconfig? I believe all that output says is that debugging was enabled. _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"