Re: Problems running ath with bgscan enabled

"Kevin Oberman" <[email protected]>
Newsgroups gmane.os.freebsd.devel.mobile
Message-ID <[email protected]>
> Date: Sun, 21 Oct 2007 19:38:56 -0700
> From: Sam Leffler <[email protected]>
> Sender: [email protected]
> 
> AT Matik wrote:
> > On Saturday 20 October 2007 22:30:32 Kevin Oberman wrote:
> >   
> >> My bgscan interval was the default 300 and almost every 5 minutes I
> >> would lose connectivity, often for over a minute. When I made the
> >> association between the bgscan interval and the drop-outs, I did an
> >> "ifconfig ath0 -bgscan" and things stabilized immediately. No further
> >> problems.
> >>
> >> ath_hal: 0.9.20.3 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413, RF5413)
> >> ath0: <Atheros 5212> mem 0xb4000000-0xb400ffff irq 11 at device 2.0 on
> >> pci11 ath0: mac 5.9 phy 4.3 radio 3.6
> >>
> >> This is really not acceptable for default behavior as it won't be clear
> >> to many how to fix it. Is it expected or is something wrong?
> >>
> >>     
> >
> > I believe it is so but as you already did, when you like to associate only to 
> > the AP of your wpa config you should set -bgscan and eventually 'roaming 
> > manual' also, if I am not wrong this is described in ifconfig's manpage
> >
> >   
> 
> wpa_supplicant works fine w/ bgscan.  When the bgscan's complete 
> wpa_supplicant receives an event and retrieves the scan results.  It 
> then decides whether or not to roam.  There is no need to manually 
> configure the device.
> 
> OTOH the scanning+roaming code in wpa_supplicant is very simplistic and 
> I don't have a lot of experience with how well it does roaming.  I 
> believe it will only join ap's that are listed in the config file so it 
> shouldn't roam arbitrarily.  Without a log it's virtually impossible to 
> comment on reports/complaints.  And even w/ a wpa_supplicant log it's 
> also useful to understand if there are other events that trigger 
> scanning and/or roaming--like beacon miss events.  Hence the need for 
> logs and statistics.

Exactly what statistics should I be collecting? I am assuming scan, but
is there anything else? assoc? Or is there some other statistic you need?
-- 
R. Kevin Oberman, Network Engineer
Energy Sciences Network (ESnet)
Ernest O. Lawrence Berkeley National Laboratory (Berkeley Lab)
E-mail: [email protected]			Phone: +1 510 486-8634
Key fingerprint:059B 2DDF 031C 9BA3 14A4  EADA 927D EBB3 987B 3751
signature.asc (application/pgp-signature, 224 B)
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.7 (FreeBSD)
Comment: Exmh version 2.5 06/03/2002

iD8DBQFHHL9/kn3rs5h7N1ERAmAoAKC4LjOp8jCRcY3OifGnVkkRtfpU4wCggEZS
I1aLEnWFsELqw49fONLLSv8=
=jNlq
-----END PGP SIGNATURE-----
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.