ACPI Attach (acpi_ibm) stops mouse from working
Tom Judge <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
Hi, I have recently setup an IBM/Lenovo T43 with RELENG_7 as of mid last week, however I have a problem with the acpi_ibm module. If I add acpi_ibm_load="YES" to loader.conf I get the following message during boot: psm0: unable to allocate IRQ This is followed by a message stating that the acpi_ibm module has attached to IRQ 12. If I remove this module from loader.conf and boot the system the mouse attaches and works as expected. If I then kldload acpi_ibm the module attaches to acpi0. Is there any way to make this work without loading the acpi module after boot? Thanks Tom _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"