Re: ACPI Attach (acpi_ibm) stops mouse from working

On Thursday 25 October 2007 04:20:49 am Tom Judge wrote:
> Kevin Oberman wrote:
> >> Date: Mon, 22 Oct 2007 17:04:52 +0100
> >> From: Tom Judge <[email protected]>
> >> Sender: [email protected]
> >>
> >> Hi,
> >>
> >>
> >> I have recently setup an IBM/Lenovo T43 with RELENG_7 as of mid last 
> >> week, however I have a problem with the acpi_ibm module.
> >>
> >> If I add acpi_ibm_load="YES" to loader.conf I get the following message 
> >> during boot:
> >>
> >> psm0: unable to allocate IRQ
> >>
> >> This is followed by a message stating that the acpi_ibm module has 
> >> attached to IRQ 12.
> >>
> >> If I remove this module from loader.conf and boot the system the mouse 
> >> attaches and works as expected.  If I then kldload acpi_ibm the module 
> >> attaches to acpi0.
> >>
> >>
> >> Is there any way to make this work without loading the acpi module after 
> >> boot?
> > 
> > I have a T43 and see the same thing if I load drivers in
> > /boot/loader.conf. I have seen it with both umass and it's USB brethren,
> > and if_ath. If I build them into the kernel or load them after the
> > system boots, there is no problem. Otherwise, no IRQ for the mouse (and
> > no mouse).
> > 
> > But you don't have to explicitly load ACPI. It's "magic" and
> > automatically loads if you don't disable it in hints. If it loads that
> > way, I have never had problems with the mouse.
> > 
> > jhb had some ideas of what caused the problem, but I have never had
> > time to pursue it and it is pretty rare.
> > 
> > Try removing the load from /boot/loader.conf and see if it works and if
> > you still get ACPI.
> 
> If I remove acpi_ibm_load="YES" from loader.conf I do indeed still get 
> acpi.  But what I don't get are access to the IBM acpi extensions such 
> as being able to use the access button to launch applications.  It all 
> seems to be related to the order in which the modules are loaded. If 
> acpi_ibm is loaded last then all is well, if not then it attaches to irq 
> 12 clobbering the ps2 port for the mouse.

I just committed a fix.  You can fix it locally by removing the IBM0057 ID 
from acpi_ibm.c.

-- 
John Baldwin
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"