Re: FreeBSD 7 doesn't see AR5212 (Netgear WPN511) via PCI/Cardbus Adapter
Warner Losh <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
> When I boot on the system that has the pci->cardbus adapter, ath isn't The pci->cardbus adapter with an ath card in it not working could be one of three things: (1) the pci bus numbering problem. (2) lack of 3.3 regulators on the card so only r2 cards can work (3) Sam's power issues I'm guessing #1 in this case. To tell if it is #1, you'll need to look to see if the subbus and such. sysctl dev.cbb will likely give me the next step in this debugging process. For my (working) laptop I see: dev.cbb.0.%parent: pci6 dev.cbb.0.domain: 0 dev.cbb.0.pribus: 6 dev.cbb.0.secbus: 7 dev.cbb.0.subbus: 7 but that's because the pribus, secbus and subbus are set right up the tree: dev.pci.6.%desc: ACPI PCI bus dev.pci.6.%driver: pci dev.pci.6.%parent: pcib3 dev.pcib.3.%desc: ACPI PCI-PCI bridge dev.pcib.3.%driver: pcib dev.pcib.3.%location: slot=20 function=4 handle=\_SB_.PCI0.P2P_ dev.pcib.3.%pnpinfo: vendor=0x1002 device=0x4371 subvendor=0x0000 subdevice=0x0000 class=0x060401 dev.pcib.3.%parent: pci0 hmmm, maybe I should add these debug diagnostics to pcib too. Warner _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"