Re: RFC: PCI SD host controller driver & mmc/mmcsd modules improvements
Alexander Motin <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.arm,gmane.os.freebsd.devel.mobile,gmane.os.freebsd.current |
|---|---|
| Message-ID | <[email protected]> |
Lars Engels wrote: > On another notebook with the same card reader I get a little further: > > sdhci0: <RICOH R5C822 SD> mem 0xd8002800-0xd80028ff irq 22 at device 9.2 > on pci5 > sdhci0: 1 slot(s) allocated > sdhci0: [ITHREAD] > mmc0: <MMC/SD bus> on sdhci0 > mmc0: detached > mmc0: <MMC/SD bus> on sdhci0 > > So the mmc device is detected everytime I insert a card and is removed > when I take the card out. It means that controller successfully reports card insertion. You must be a half way there. > But I do not get a new disk device... A bit more debugging can be produced with enabling verbose boot messages. > pciconf tells me pretty much the same like on the other notebook: Looks like it may depend or on controller version or on the way it is hardwired or somehow BIOS initialized. There are were some success stories reported with this controller. -- Alexander Motin _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-arm To unsubscribe, send any mail to "[email protected]"