Re: RFC: PCI SD host controller driver & mmc/mmcsd modules improvements
"M. Warner Losh" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.arm,gmane.os.freebsd.current,gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
In message: <[email protected]> Alexander Motin <[email protected]> writes: : Lars Engels wrote: : > On another notebook with the same card reader I get a little further: : > : > sdhci0: <RICOH R5C822 SD> mem 0xd8002800-0xd80028ff irq 22 at device 9.2 : > on pci5 : > sdhci0: 1 slot(s) allocated : > sdhci0: [ITHREAD] : > mmc0: <MMC/SD bus> on sdhci0 : > mmc0: detached : > mmc0: <MMC/SD bus> on sdhci0 : > : > So the mmc device is detected everytime I insert a card and is removed : > when I take the card out. : : It means that controller successfully reports card insertion. You must : be a half way there. : : > But I do not get a new disk device... : : A bit more debugging can be produced with enabling verbose boot messages. : : > pciconf tells me pretty much the same like on the other notebook: : : Looks like it may depend or on controller version or on the way it is : hardwired or somehow BIOS initialized. There are were some success : stories reported with this controller. Add mmcsd to the kernel? Load it as a module? Warner _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-arm To unsubscribe, send any mail to "[email protected]"