Re: Comms quality/signal noise stat

Intersil cards 'not associated' signal rate always shows 0 quality, 27 link
strength and 27 noise., the current BSS will also show as 44:44:44:44:44:44
at this time.

Once you successfuly associate with an AP, you'll notice the numbers will
show your current signal levels.

----- Original Message ----- 
From: "Vinod" <[email protected]>
To: <[email protected]>
Sent: Sunday, August 04, 2002 8:57 PM
Subject: Comms quality/signal noise stat


> 
> can anybody explain to me a little bit more about the
> Comms quality/signal noise stat appearing with
> wicontrol . it always seems to show [ 0 27 27 ].how
> can this stat be used to monitor the current S/N
> ratio,if it can at all.
> Would appreciate the help.can't seem to make much out
> of it right now. 
> Thanks in advance,
> Vinod
> 
>  
> 
> __________________________________________________
> Do You Yahoo!?
> Yahoo! Health - Feel better, live better
> http://health.yahoo.com
> 
> To Unsubscribe: send mail to [email protected]
> with "unsubscribe freebsd-mobile" in the body of the message
> 


To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message