Re: Comms quality/signal noise stat

no i see the [0 27 27] when i am associated in ad-hoc
mode with another PC.i use orinoco cards.
Vinod
--- Tony Toole <[email protected]> wrote:
> Intersil cards 'not associated' signal rate always
> shows 0 quality, 27 link
> strength and 27 noise., the current BSS will also
> show as 44:44:44:44:44:44
> at this time.
> 
> Once you successfuly associate with an AP, you'll
> notice the numbers will
> show your current signal levels.
> 
> ----- Original Message ----- 
> From: "Vinod" <[email protected]>
> To: <[email protected]>
> Sent: Sunday, August 04, 2002 8:57 PM
> Subject: Comms quality/signal noise stat
> 
> 
> > 
> > can anybody explain to me a little bit more about
> the
> > Comms quality/signal noise stat appearing with
> > wicontrol . it always seems to show [ 0 27 27
> ].how
> > can this stat be used to monitor the current S/N
> > ratio,if it can at all.
> > Would appreciate the help.can't seem to make much
> out
> > of it right now. 
> > Thanks in advance,
> > Vinod
> > 
> >  
> > 
> > __________________________________________________
> > Do You Yahoo!?
> > Yahoo! Health - Feel better, live better
> > http://health.yahoo.com
> > 
> > To Unsubscribe: send mail to [email protected]
> > with "unsubscribe freebsd-mobile" in the body of
> the message
> > 
> 
> 
> To Unsubscribe: send mail to [email protected]
> with "unsubscribe freebsd-mobile" in the body of the
message


__________________________________________________
Do You Yahoo!?
Yahoo! Health - Feel better, live better
http://health.yahoo.com

To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message