Re: Comms quality/signal noise stat

[Format recovered--see http://www.lemis.com/email/email-format.html]

Multiple mutilation.

On Sunday,  4 August 2002 at 21:24:14 -0700, Vinod wrote:
> --- Tony Toole wrote:
>> On  Sunday, August 04, 2002 8:57 PM, Vinod wrote:
>>> can anybody explain to me a little bit more about the Comms
>>> quality/signal noise stat appearing with wicontrol . it always
>>> seems to show [ 0 27 27 .how can this stat be used to monitor the
>>> current S/N ratio,if it can at all.  Would appreciate the
>>> help.can't seem to make much out of it right now.
>>
>> Intersil cards 'not associated' signal rate always shows 0 quality,
>> 27 link strength and 27 noise., the current BSS will also show as
>> 44:44:44:44:44:44 at this time.
>>
>> Once you successfuly associate with an AP, you'll notice the
>> numbers will show your current signal levels.
>
> no i see the [0 27 27] when i am associated in ad-hoc mode with
> another PC.i use orinoco cards.

Yes, this is normal with these cards in demo ad-hoc or IBSS modes.

Greg
--
When replying to this message, please take care not to mutilate the
original text.  
For more information, see http://www.lemis.com/email.html
See complete headers for address and phone numbers

To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message