Compaq EVO N800c and acpi and usb wavelan

I got this new Compaq laptop running with CURRENT except for
a few things. ACPI hangs the machine during boot. It doesn't
help to do as said in UPDATING, put hint.acpi.0.disable="1"
in /boot/loader.conf

I have to do:
ok> unset acpi_load
and then boot.

The second thing is the built in wavelan card. It is detected as
(from dmesg) 
ugen0: Compaq Computers Compaq WLAN MultiPort W200, rev 1.10/0.00, addr 3

Is there any work going on to get such a USB-device working? And is there
any work going on to get the ACPI working on Compaq?

here's my full dmesg. Current is as from cvsup today

Copyright (c) 1992-2003 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD 5.0-CURRENT #0: Wed Jan  8 16:27:46 CET 2003
    [email protected]:/usr/obj/usr/src/sys/POOH
Preloaded elf kernel "/boot/kernel/kernel" at 0xc0501000.
Timecounter "i8254"  frequency 1193182 Hz
Timecounter "TSC"  frequency 1794187572 Hz
CPU: Pentium 4 (1794.19-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0xf24  Stepping = 4

+Features=0x3febf9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PA T,PSE36,CLFLUSH,DTS,ACPI,MMX,FXSR,SSE,SSE2,SS,HTT,TM>
  Hyperthreading: 1 logical CPUs
real memory  = 536674304 (511 MB)
avail memory = 515960832 (492 MB)
Initializing GEOMetry subsystem
Pentium Pro MTRR support enabled
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Host to PCI bridge> at pcibus 0 on motherboard
pci0: <PCI bus> on pcib0
agp0: <Intel 82845 host to AGP bridge> mem 0x60000000-0x6fffffff at device 0.0 on pci0
pcib1: <PCI-PCI bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
pci1: <display, VGA> at device 0.0 (no driver attached)
pcib2: <PCI-PCI bridge> at device 30.0 on pci0
pci2: <PCI bus> on pcib2
pci2: <simple comms> at device 4.0 (no driver attached)
cbb0: <TI1410 PCI-CardBus Bridge> mem 0x40000000-0x40000fff irq 11 at device 6.0 on pci2
cardbus0: <CardBus bus> on cbb0
pccard0: <16-bit PCCard bus> on cbb0
fxp0: <Intel Pro/100 Ethernet> port 0x2400-0x243f mem 0x40080000-0x40080fff irq 10 at device 8.0 on pci2
fxp0: Ethernet address 00:08:02:66:cd:09
inphy0: <i82562ET 10/100 media interface> on miibus0
inphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
ohci0: <NEC uPD 9210 USB controller> mem 0x40100000-0x40100fff irq 10 at device 14.0 on pci2
usb0: OHCI version 1.0, legacy support
usb0: SMM does not respond, resetting
usb0: <NEC uPD 9210 USB controller> on ohci0
usb0: USB revision 1.0
uhub0: NEC OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 3 ports with 3 removable, self powered
ums0: Logitech USB Receiver, rev 1.10/9.10, addr 2, iclass 3/1
ums0: 5 buttons and Z dir.
ugen0: Compaq Computers Compaq WLAN MultiPort W200, rev 1.10/0.00, addr 3
ohci1: <NEC uPD 9210 USB controller> mem 0x40180000-0x40180fff at device 14.1 on pci2

hci1: Could not allocate irq
device_probe_and_attach: ohci1 attach returned 6
pci2: <serial bus, USB> at device 14.2 (no driver attached)
isab0: <PCI-ISA bridge> at device 31.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel ICH3 ATA100 controller> port 0x4440-0x444f,0-0x3,0-0x7,0-0x3,0-0x7 irq 11 at device 31.1 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
pci0: <multimedia, audio> at device 31.5 (no driver attached)
orm0: <Option ROM> at iomem 0xc0000-0xcffff on isa0
pmtimer0 on isa0
atkbdc0: <Keyboard controller (i8042)> at port 0x64,0x60 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model Generic PS/2 mouse, device ID 0
fdc0: <Enhanced floppy controller (i82077, NE72065 or clone)> at port 0x3f7,0x3f0-0x3f5 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode
ppc0: FIFO with 16/16/8 bytes threshold
plip0: <PLIP network interface> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
unknown: <PNP0303> can't assign resources (port)
unknown: <PNP0f13> can't assign resources (irq)
unknown: <PNP0401> can't assign resources (port)
unknown: <PNP0501> can't assign resources (port)
unknown: <PNP0700> can't assign resources (port)
unknown: <PNP0c02> can't assign resources (memory)
Timecounters tick every 10.000 msec
IPsec: Initialized Security Association Processing.
ad0: 28615MB <FUJITSU MHR2030AT> [58140/16/63] at ata0-master UDMA100
acd0: CD-RW <HL-DT-STCD-RW/DVD DRIVE GCC-4240N> at ata1-master PIO4
Mounting root from ufs:/dev/ad0s1a

On the boot when not disabling ACPI it says (just before going
into debug):

Copyright (c) 1992-2003 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD 5.0-CURRENT #0: Wed Jan  8 16:27:46 CET 2003
    [email protected]:/usr/obj/usr/src/sys/POOH
Preloaded elf kernel "/boot/kernel/kernel" at 0xc054b000.
Preloaded elf module "/boot/kernel/acpi.ko" at 0xc054b0a8.
Timecounter "i8254"  frequency 1193182 Hz
Timecounter "TSC"  frequency 1794189396 Hz
CPU: Pentium 4 (1794.19-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0xf24  Stepping = 4

+Features=0x3febf9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,CLFLUSH,DTS,ACPI,MMX,FXSR,SSE,SSE2,SS,HTT,TM>
  Hyperthreading: 1 logical CPUs
real memory  = 536674304 (511 MB)
avail memory = 515653632 (491 MB)
Initializing GEOMetry subsystem
Pentium Pro MTRR support enabled
npx0: <math processor> on motherboard
npx0: INT 16 interface
acpi0: <COMPAQ CPQ004A > on motherboard

-- 
Gunnar Flygt, Postmaster SR

To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message