Re: HP Omnibook XE2-db: XFree86 4.3.0 core dumps
Christian Sauer <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
Gunnar Flygt said: > On Fri, Mar 21, 2003 at 12:03:18AM -0500, Christian Sauer wrote: >> >> After installing XFree86 4.3.0 via ports to the omnibook, I built the >> config file using xf86config utility. When I try to run startx, >> XFree86 goes through it's startup routine and the screen flickers like >> it is about to go into graphics mode. It then core dumps and returns >> to the command line. > > Try using the more modern xf86cfg instead! Already tried that. Same results. >> >> I have found a bunch of stuff online about using this laptop with >> XFree86 v3 ... but nothing for v4. >> >> According to >> http://h200005.www2.hp.com/bc/docs/support/SupportManual/bpi03591/bpi03591.pdf >> This video chip is "SMI LynxE SM811 graphics controller with 2-MB >> 135-MHZ SGRAM" >> >> Anyone have any advice? >> >> -Christian >> [system info output snipped] > > -- > Gunnar Flygt > OPC Data > Sveriges Radio -Christian To Unsubscribe: send mail to [email protected] with "unsubscribe freebsd-mobile" in the body of the message