Help Config Sound in Dell Inspiron 4100

Hi
 I successfuly installed the FreeBSD4.5 on it and
 X-windows with Kde2 on Dell Inspiron 4100 Laptop .but
 i am not able to configure the modem and sound card
 .It has PCtel Modem & Crystal 4205 Sound card .Can
any
 body tell how to configure the Sound and Modem .

here is output of dmesg. i also try same thing which u
 mentioned . I recompile the kernle with
 device pcm
 device csa

Bye
Sonam 

The Output Of dmesg:......

Copyright (c) 1992-2002 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989,
1991, 1992, 1993, 1994
The Regents of the University of California. All
rights reserved.
FreeBSD 4.5-RELEASE #0: Sun Apr  7 10:49:54 IST 2002
   
[email protected]:/usr/src/sys/compile/SON_KER2_1
Timecounter "i8254"  frequency 1193182 Hz
CPU: Pentium III/Pentium III Xeon/Celeron (863.79-MHz
686-class CPU)
  Origin = "GenuineIntel"  Id = 0x6b1  Stepping = 1
 
Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE>
real memory  = 134094848 (130952K bytes)
config> di sn0
config> di lnc0
config> di le0
No such device: le0
Invalid command or syntax.  Type `?' for help.
config> di ie0
config> di fe0
config> di ed0
config> di cs0
config> q
avail memory = 125517824 (122576K bytes)
Preloaded elf kernel "kernel" at 0xc04e1000.
Preloaded userconfig_script "/boot/kernel.conf" at
0xc04e109c.
Pentium Pro MTRR support enabled
md0: Malloc disk
Using $PIR table, 11 entries at 0xc00fbba0
apm0: <APM BIOS> on motherboard
apm: found APM BIOS v1.2, connected at v1.2
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
pcib1: <PCI to PCI bridge (vendor=8086 device=3576)>
at device 1.0 on pci0
pci1: <PCI bus> on pcib1
pci1: <ATI model 4c59 graphics accelerator> at 0.0 irq
11
uhci0: <UHCI (generic) USB controller> port
0xbf80-0xbf9f irq 11 at device 29.0 on pci0
uhci0: (New UHCI DeviceId=0x24828086)
usb0: <UHCI (generic) USB controller> on uhci0
usb0: USB revision 1.0
uhub0: (0x24828086) UHCI root hub, class 9/0, rev
1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
pcib2: <PCI to PCI bridge (vendor=8086 device=2448)>
at device 30.0 on pci0
pci2: <PCI bus> on pcib2
pcic0: <TI PCI-1420 PCI-CardBus Bridge> irq 11 at
device 1.0 on pci2
pcic0: PCI Memory allocated: 0x44000000
pcic0: TI12XX PCI Config Reg: [ring enable][speaker
enable][CSC serial isa irq]
pccard0: <PC Card bus (classic)> on pcic0
pcic1: <TI PCI-1420 PCI-CardBus Bridge> irq 11 at
device 1.1 on pci2
pcic1: PCI Memory allocated: 0x44001000
pcic1: TI12XX PCI Config Reg: [ring enable][speaker
enable][CSC serial isa irq]
pccard1: <PC Card bus (classic)> on pcic1
isab0: <PCI to ISA bridge (vendor=8086 device=248c)>
at device 31.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel ICH3 ATA100 controller> port
0xbfa0-0xbfaf,0x374-0x377,0x170-0x177,0x3f4-0x3f7,0x1f0-0x1f7
irq 0 at device 31.1 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
pcm0: <Intel 82801CA (ICH3)> port
0xdc80-0xdcbf,0xd800-0xd8ff irq 11 at device 31.5 on
pci0
pci0: <unknown card> (vendor=0x8086, dev=0x2486) at
31.6 irq 11
orm0: <Option ROMs> at iomem
0xc0000-0xcefff,0xcf000-0xcf7ff,0xcf800-0xcffff on
isa0
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7
irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <Keyboard controller (i8042)> at port
0x60,0x64 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model Generic PS/2 mouse, device ID 0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem
0xa0000-0xbffff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1: configured irq 3 not in bitmap of probed irqs 0
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on
isa0
ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in
COMPATIBLE mode
ppc0: FIFO with 16/16/8 bytes threshold
plip0: <PLIP network interface> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
pccard: card inserted, slot 0
pccard: card removed, slot 0
pcic0: Card type 32-bit cardbus is unsupported
ad0: 19077MB <IC25N020ATDA04-0> [38760/16/63] at
ata0-master UDMA100
acd0: CDROM <LG CD-ROM CRN-8245B> at ata1-master using
PIO4
Mounting root from ufs:/dev/ad0s2a





__________________________________________________
Do You Yahoo!?
Yahoo! Games - play chess, backgammon, pool and more
http://games.yahoo.com/

To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message