RE: ACPI and INT-Routing
Markus D. <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
> > > I have seen in DMESG output from people posting to this list entries > > like 'slot 31 INTD is routed to irq 3'. Is it an error not to have such > > lines on booting with acpi? > > It is not an error, per se. It may mean that your BIOS doesn't > support interrupt routing, but I doubt that. > > > Instead the irq's are displayed along with the driver lines on booting. > > Can you provide an example of this? > It look's like this (with OLDCARD) pcic0: <O2micro 6812/6872 PCI-Cardbus Bridge> irq 11 at device 3.0 on pci0 pcic0: PCI Memory allocated: 0x88000000 pcic0: Polling mode pcic0: Warning: O2micro OZ68xx chips may not work pccard0: <PC Card 16-bit bus (classic)> on pcic0 _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"