Re: ACPI and INT-Routing
"M. Warner Losh" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
In message: <[email protected]> "Markus D." <[email protected]> writes: : > : > > I have seen in DMESG output from people posting to this list entries : > > like 'slot 31 INTD is routed to irq 3'. Is it an error not to have such : > > lines on booting with acpi? : > : > It is not an error, per se. It may mean that your BIOS doesn't : > support interrupt routing, but I doubt that. : > : > > Instead the irq's are displayed along with the driver lines on booting. : > : > Can you provide an example of this? : > : It look's like this (with OLDCARD) : : pcic0: <O2micro 6812/6872 PCI-Cardbus Bridge> irq 11 at device 3.0 on pci0 : pcic0: PCI Memory allocated: 0x88000000 : pcic0: Polling mode : pcic0: Warning: O2micro OZ68xx chips may not work : pccard0: <PC Card 16-bit bus (classic)> on pcic0 OLDCARD doesn't have the new, shiny o2micro workarounds in it. Warner _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"