Re: Thinkpad 600E and 5.2
Scott Mitchell <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
On Thu, Jul 29, 2004 at 10:08:44AM -0700, Gary Kline wrote: > Closer. After I rebuild the kernel with target OLDCARD, and > rebooted (withh Xircom Ethernet II 10/100 inserted, no more > kernel traps. > > I added > > pccard_ether xe0 start link0 > > to rc.conf and rebooted. Zero. The cabling is solid. > The defaultrouter="10.0.0.1" entry doesn't seem to > have any effect. I set get the "Setup PC-CARD" message > when coming up. How do I get into this setup? Am I > missing some sysctl cmd? Anything else? > > gary Hi Gary, Could you post your full /etc/rc.conf and /var/run/dmesg.boot? The hardware you've got there should work, so I'm guessing this is just a configuration issue. For reference, the only stuff I have in my rc.conf to enable xe0 on my TP380D is: ifconfig_xe0="DHCP" pccard_enable="YES" If you're not using DHCP, obviously put something else in the ifconfig_xe0 line. Using pccard_enable is important - you're running an OLDCARD kernel so you need to make sure that pccardd is started to attach the card. Cheers, Scott -- =========================================================================== Scott Mitchell | PGP Key ID | "Eagles may soar, but weasels Cambridge, England | 0x54B171B9 | don't get sucked into jet engines" scott at fishballoon.org | 0xAA775B8B | -- Anon _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"