Re: Thinkpad 600E and 5.2

On Sat, Jul 31, 2004 at 05:39:21PM +0100, Scott Mitchell wrote:
> On Thu, Jul 29, 2004 at 10:08:44AM -0700, Gary Kline wrote:
> > 	Closer. After I rebuild the kernel with target OLDCARD, and 
> > 	rebooted (withh Xircom Ethernet II 10/100 inserted, no more
> > 	kernel traps.
> > 
> > 	I added  
> > 
> > 	 pccard_ether xe0 start link0
> > 
> > 	to rc.conf and rebooted. Zero.  The cabling is solid.  
> > 	The   defaultrouter="10.0.0.1"  entry doesn't seem to
> > 	have any effect.  I set get the "Setup PC-CARD" message
> > 	when coming up.  How do I get into this setup?  Am I
> > 	missing some sysctl cmd?  Anything else?
> > 
> > 	gary
> 
> Hi Gary,
> 
> Could you post your full /etc/rc.conf and /var/run/dmesg.boot?  The
> hardware you've got there should work, so I'm guessing this is just a
> configuration issue.
> 
> For reference, the only stuff I have in my rc.conf to enable xe0 on my
> TP380D is:
> 	ifconfig_xe0="DHCP"
> 	pccard_enable="YES"
> 
> If you're not using DHCP, obviously put something else in the ifconfig_xe0
> line.  Using pccard_enable is important - you're running an OLDCARD kernel
> so you need to make sure that pccardd is started to attach the card.
> 

	Hm. I'm running GENERIC again,  after running with the OLDCARD
	configuration failed.  The system does recognize my Xircom,
	but as "dc0"  But when I boot with ifconfig_dc0="DHCP" I 
	run into 'watchdog timeout' errs (prob'ly from dhclient).

	My card is a Xircom Ethernet II 10/100 CBE2-100.  If your
	card is identical, I'll go back to the OLDCARD conf and
	try again.

	thanks much,

	gary



-- 
   Gary Kline     [email protected]   www.thought.org     Public service Unix

_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"