Re: Blackbird version to install (was: Re: Blackbird Support)

> On 25. Aug 2019, at 14:02, Mark Linimon <[email protected]> wrote:
> 
> Here's what I'm running on mine:
> 
>  blackbird1% uname -a
>  FreeBSD blackbird1.lonesome.com 13.0-CURRENT FreeBSD 13.0-CURRENT r349478 GENERIC  powerpc
>  blackbird1% uptime
>  12:01PM  up 42 days,  7:28, 6 users, load averages: 0.23, 0.16, 0.14
> 
> Are you perhaps being caught in this trap?
> 
>  https://wiki.freebsd.org/powerpc/Raptor/Blackbird#Tips_and_Tricks
I just tested it, and this is still an issue.

I configured the system that it automatically selects FreeBSD (since I can't do that via a keyboard),
and I don't see the FreeBSD output on the Monitor unless I apply D15818 and manually deal with merge
conflicts. Then I do see the output in yellow...

Except for updating the patch to apply cleanly, what is needed to get it in the tree.
Automatically selecting the OS to boot seems a nice feature even with a Monitor/Keyboard
attached.

Best regards
Michael
> 
> mcl
> _______________________________________________
> [email protected] mailing list
> https://lists.freebsd.org/mailman/listinfo/freebsd-ppc
> To unsubscribe, send any mail to "[email protected]"