Re: Blackbird version to install (was: Re: Blackbird Support)

I followed that tip and have a monitor attached via VGA. I can select the
freebsd install, but the system would crash during the boot process.

However, I think it may be my board.  I tried installing openSUSE
Tumbleweed and after it installed it crashed during startup. Now the system
shuts down during IPL with errors about “no functional no chiplets.  It
continues to loop through this process until I power it off.



On Sun, Aug 25, 2019 at 8:02 AM Mark Linimon <[email protected]> wrote:

> Here's what I'm running on mine:
>
>   blackbird1% uname -a
>   FreeBSD blackbird1.lonesome.com 13.0-CURRENT FreeBSD 13.0-CURRENT
> r349478 GENERIC  powerpc
>   blackbird1% uptime
>   12:01PM  up 42 days,  7:28, 6 users, load averages: 0.23, 0.16, 0.14
>
> Are you perhaps being caught in this trap?
>
>   https://wiki.freebsd.org/powerpc/Raptor/Blackbird#Tips_and_Tricks
>
> mcl
>
_______________________________________________
[email protected] mailing list
https://lists.freebsd.org/mailman/listinfo/freebsd-ppc
To unsubscribe, send any mail to "[email protected]"