Re: FirePro M5100 Support in drm-next-kmod?

Doug Kirk <[email protected]>
Newsgroups gmane.os.freebsd.devel.x11
Message-ID <CAGhTqAV1Aop5dr9uQm80J9JdP4Ks+VjpEdRgK4J6DRH28PDK1A@mail.gmail.com>
From what I understand, you should probably try

  kld_list="/boot/modules/amdgpu"

in rc.conf to ensure you're picking up the port kmod instead of the base
kmod.

On Tue, Oct 23, 2018 at 2:45 PM Jacob Meadows <[email protected]> wrote:

> I am testing FreeBSD on a Dell Latitude M4800 with an AMD FirePro M5100
> mxm video card.  On a clean install, I install drm-next-kmod from ports,
> then add kld_list="amdgpu" to the /etc/rc.conf.  On reboot, the system
> freezes during the driver loading, and I have to physically power off the
> system and boot into single user mode to disable the driver and recover.
>
> I have tried this in 11.2 and 12.0 Beta1.  I have tried drm-stable-kmod as
> well.  I have tried this in both UEFI and legacy boot modes, but it happens
> the same each time.  If I load the i915 driver, that loads without issue.
>
> I run "pciconf –lv | grep display –B 3 –A" and get the following result:
>
> Vgapci1@pci0:0:2:0:     Class=0x030000 card=0x05cc1028 chip=0x04168086
> rev=0x06 hdr=0x00
>         Vendor  = ‘Intel Corporation’
>         Device  = ‘4th Gen Core Processor Integrated Graphics Controller’
>         Class   = display
>         Subclass = VGA
> --
> Vgapci0@pci0:1:0:0:     class-0x030000 card=0x05cc1028 chip=0x68211002
> rev=0x00 hdr=0x00
>         Vendor  = ‘Advanced Micro Devices, Inc. [AMD/ATI]’
>         Device  = ‘Venus XT [Radeon HD 8870M / R9 M270X/M370X]’
>         Class   = display
>         Subclass        = VGA
>
>
> I do see an error during boot, but otherwise seems to be ok:
> Radeon/verde_me.bin: could not load firmware image, error 2
> Radeon/verde_me.bin: could not load firmware image, error 2
> Radeon/verde_ce.bin: could not load firmware image, error 2
> Radeon/verde_ce.bin: could not load firmware image, error 2
> Radeon/verde_rlc.bin: could not load firmware image, error 2
> Radeon/verde_rlc.bin: could not load firmware image, error 2
>
> My question is this:  Is this particular card unsupported, or is there
> something I am missing?
> _______________________________________________
> [email protected] mailing list
> https://lists.freebsd.org/mailman/listinfo/freebsd-x11
> To unsubscribe, send any mail to "[email protected]"
>
_______________________________________________
[email protected] mailing list
https://lists.freebsd.org/mailman/listinfo/freebsd-x11
To unsubscribe, send any mail to "[email protected]"
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.